Power Conditioner Manufacturers in Bangalore

Home Products

Power Conditioner

Power Conditioner

FARMAX three-phase power conditioners are built with the best-quality filters to deal with surges, sags, over-voltage, noises, notches, long-term interruption, momentary interruption, and frequency variations. So, we assure 100% quality power to enable the best functioning of electric and electronic equipment. They avoid certain unnecessary power issues like data loss, visual and audio disturbances, etc.

Superior quality filters are used in these units - they deal with transient voltage surges, noise, notches, sags, under-voltage, over-voltage, long-term interruption, momentary interruption, and frequency variation. Ultimately, the best power quality is ensured through our power conditioners to any associated equipment.

We are considered as one of the best Power Conditioner manufacturers in Bangalore with more satisfied customers. We manufacture reliable and top-grade Power Conditioners with advanced and latest technologies and also ensure the safety of electronic appliances.

Download Brochure

The use of high insulating materials and special shielding techniques results in an attenuating common mode and minimizes transverse mode noise
The core and its magnetic properties are properly selected to provide sufficient leakage inductance. This will give the greatest attenuation of normal mode power line noise possible, consistent with the transfer of fundamental power frequency, while all higher frequencies are blocked
Due to the better regulation, it does not generate common mode impedance coupling effect
Protect against strong lightening, impulse noise, bus short-circuit, accidental discharge of capacitors, etc
Protect the Micro processor based machines and equipment's from damage due to electrical noise, spikes etc.
Enable stable power output even under severe voltage fluctuations zero wave-form distortion

Specification Input Voltage 340V to 460V or 360V to 460V line-to-line, 3 phase 4-wire system
Output Voltage 415 V3Ph/220V 3Ph as per requirement
Rate of Correction 70V / 30V/25V per Sec
Response Time 10 m sec.
Connection Delta/Star
Efficiency 98 %
Ratio 1:1 And 2:1
Regulation Better than 3.5%
Power Factor 0.75 Lead to .75 Lag
Di-Electric strength 3kv for 60 Sec
Insulation Resistance Better tan 500 Mega Ohms
Coupling Capacitance 0.01pF for 100 dB
Leakage Current < 20 Micro Amps
Common Mode Attenuation 100 db./ 120 db.
Line Frequency 47 to 63 HZ
Control Type Digital Micro controller base
Operating temperature 0o C - 45o C Ambient
Nature of cooling Natural air/ Forced air
Protections Electronic over voltage trip

Electronic under voltage trip

Overload and short circuit protection

Single phasing prevention & cut off

Phase reversal protection & cut off

Metering LCD type Input voltage P-N

Output voltage P-P

Load current in all phases